Wire Wrapped Seashell Ornaments

The wire wrapped seashell ornaments are great for a nautical themed Christmas tree or any other time of the year.

We had a few seashells that had holes in them so we used the holes for easier wire work. The holes were so helpful, we decided to make holes in the other shells. We tapped the seashell a couple times with something pointy (like needle nose pliers) and sometimes we broke the seashell but it usually made a hole.

 

Steps for Wire Wrapped Seashell Ornaments

 

Your wire wrapped seashell ornaments will no doubt have your own touch and creativity in them, so don’t worry yourself by trying to make them look exactly like these. The instructions below are the basics of what we did.

  1. We took about 12 inches or more (didn’t measure) of wire and began to wrap it around the shell by going through the hole. We extended one end of wire toward the top of the shell and left a few inches to create the hook to hang it. Go around the seashell and through the hole 1 to 3 times, each shell we did was different.
  2. Add some beads or embellishments that you like by threading them onto the wire as you wrap it around the shell. Try not to tighten the wire too much, you might break the shells. (I did a lot of swearing)
  3. We usually added more beads at the end of the wire and created a tight spiral to hold them in place.

We used copper because we like the look but you can use whatever color you want. Same with beads and seashells. You don’t need to make a hole in the shell either, but you will likely use more wire without the hole.

Check out a few more we made below….

[Email Subscribe]

Follow Us

Comments

  1. Spectacular! They look amazing. Love the copper!

  2. Copper kills tillandsia plants. Its toxic to them. Try using a different metal.